F615029 - $200.50
F616029 - $200.50
F658095 - $298.35
F85095 - used $47.50
F525301 - $164.45
F286015 - $47.00
F15037 - $17.35
FA141298 Bearing Cage
F658029 - $120.55
F525029 - $97.75
F522144 - $50.40
F15057 - $22.32
F475029 - $145.15
CHRYSLER OUTBOARD PARTS
FA286298 - Cage
F12057 Coil - $125.70
F12226 Coil - $85.75
F2A318298 Bearing Cage $45.57
F12211 - Coil - $54.50
New 3 cylinder cap base $125.00 Missing center brush (2 available)
FA324298 - Cage - $63.15
F287098 $186.85
F28054 $42.50
F901532 $24.50
F525079 -used handle - $65.00
Used Force trim handle $75.00
F525015 - Piston - $53.75
F197032 - $23.50
F5H054 - $51.05
F474266 - $84.30
FA485662 - $143.75
FA485023 - $157.25
F14004 - USED 3 CYL ROTOR - $71.50
F14042 - USED HSNG WITH CLAMPS $57.60
F523706 COVER - OLD STYLE DRIVE SHAFT $37.65
FA77265 USED PIN DRIVE $37.50
Used rebuildable SPC180 --13 1/4 x 17 $65.00
7 1/2 x 8 or 9 - 9 SPLINE STAINLESS DEMO $61.50
F5H094 STEERING LINK $46.10
F197688 Handle $17.50
F286079 used assy $45.00
F286079 $39.50
F525518 $43.10
F390456 $32.80
F312616 $33.05
F15601 $27.25
F12386 $69.15
F550706 COVER - NEW STYLE DRIVE SHAFT $53.55
PR434 - 11 1/4 x 13 60 HP $80.00
FP317- 7 x 4 3/4 9 SPLINE 6/7.5 HP $52.50
FP275 - 10 1/2 x 15 35/45 HP $70.00
FP468- 7 1/2 x 6 PIN DRIVE ALUM $47.75
FP409265 8 x 5 9 SPLINE 6/7.5 HP ALUM $52.50
F84529 - Head Gasket - $49.50
F50521 (9.2) - $60.29
F901721 (9.2) - $21.95
F197662 (9.2) - $108.72
F94094 - Prop Cone - $8.99
F498891 Pivot Pin - $5.75
F90891 Pivot Pin - $5.95
F178529 - Head Gasket - $42.80
F532299 - Spacer - $17.95
F286078 - New - $85.70 steering bracket
F5H161 control box with trim handle and cables
New tilt cylinder - $139.50 with lines
42653A 3 OEM gas cap $21.61
F197453 - Base gasket - $13.75
F197767 - Engine end - $16.35
F684475 - Coil - $88.27
F685301 - CD Box - $319.50
F658475 - CD/Coil - $325.00
F15113 Bendix - $47.55
F15056 Bendix - $97.25
F15037 Starter end cap - $17.35
F15057 Brush holder - $22.32
F392756 Hood Seal - $15.60
F369450 Rectifier - $69.94
F522144 Upper cover - $50.40
F523485 Anode - $14.05
F345475 (used) 0ld style - $45.00
F345475 New style - $107.45
F289924 Used solenoid - $45.00
F525018 - used crank - $80.00 7.5 hp Chrysler Sailor
F191239 - used spool - $67.50
F183239 - used spool - $57.50
Updated 7/24/10
F85965 - Used motor mounts - $34.50 each
Powerflo lower unit from parted out 85 hp Chrysler engine. Drained, pressure tested and refilled - no water or metal in old oil. Bench shifts okay. Sold as is - for an additional $250.00 I can completely tear down and rebuild this unit for you. $750.00
Additional shipping will apply - email with your postal or zip for rates.
2 piece lower unit from a parted out 75 hp Chrysler engine. Drained, pressure tested and refilled - no water or metal in old oil. Bench shifts okay. Sold as is - for an additional $200.00 I can completely tear down and rebuild this unit for you. $650.00
Additional shipping will apply - email with your postal or zip for rates.
F40867 - Jacket cover gasket - $19.50
20 hp USED L/U no driveshaft $275.00 FC78054
F525529 - Head gasket - $21.50
F5H202 Trailer bracket - $35.10
F681970 Rewind spring - $19.69
F2A36016 Rod - $45.98
F474030 Capacitor - $37.22
F474095 Stator - $42.13
F404030 Capacitor - $14.99
USED F335016 Rods - $15.00 each Older style available (bearings in piston)
FA335260 Ring set - $35.89 2 rings per set
F474529 - Head gasket - $46.25
F372529 - Head gasket - $59.45
F92924 Used solenoid - $45.00
F665944 Cowling - $28.10
F318529 - Head gasket - $21.85
F318453 - Base gasket - $6.95
F475095 - Stator - $353.75 35/50 hp
F197787 Fuel coupler - $19.52
F178154 - Exh. Gasket - $21.75
F531299 (60hp) - used $15.00
F50411 (9.2) - $14.65
F197023 (9.2) - $111.20
FA286054/286298 - $125.00
USED
F92498 Woodruff Key
$8.00 each -35/45/55hp
F85311 - $29.05
FA286582 $66.95